I'm planning out a Dual Build System and have been struggling to plan out how to setup my system to have two builds in one custom loop (all watercooling parts are EK and Loop fans (Corsair) will utilise Commander Pro's and Light Node Pro's currently planning to use 25 fans in push/pull configuration). I'm new to the Corsair Forums and have been reading your thread over the past few months for inspiration on my own Corsair Obsidian 1000D Build. I'll try to take pictures of whatever I get done when I get it done, in the name of sharing for others who encounter the similar questions. Even seeing the rad spacing as they sit on the fan panel is instructive, and helps with the concern. One of my rads finally came in today, it's waiting at the store - so I should be able to get some actual on-hand measurements and start confirming assumptions.Ĭheers, and thanks for providing. i've got a handful of male-to-male bitspowers that match and a collection of different sized male-to-female spacers so I should be able to make that work. Where you have the elbows and shorter hard-tube compressions on either end and then tube between, I would have to go either:ġ) elbow to soft-tube compression to like thirty milimeters of tube (doubtful if it can be done far as I see, not enough room for the compression sleeves to move around on that short bit of tubing between the two sides, barring some 'mount one side fully, put the loose sleeve on as far away from the barb on second side arrangement), orĢ) elbow to spacer fittings all the way across, which is my backup plan just gotta work out the actual travel distance. Gives me a bit of an idea anyhow with relative sizing.

Runner up. corsair obsidian 1000d.